Instructions for using the wax(refill)heater

The wax in the wax refills is liposoluable wax: it is very important that the skin is free of oil when you start waxing (as well as clean and dry)!

If you have never waxed before, test the wax 24 hours before waxing on a small section of your skin.

Instructions for using the wax (refill) heater

1) insert the wax refill into the wax heater;
2) plug into power socket;
3) after about 30 minutes the wax has reached the ideal temperature;
4) unplug the wax heater: the wax will remain at the correct temperature for approximately 15/20 minutes. If treatment takes longer than this, plug the wax heater into the power socket again for another 5 – 10 minutes;
5) use the prewax lotion (Voorbehandelingslotion) to cleanse and disinfect the skin;
6) apply talcum powder on the skin to absorb moist and oil (when you use (night)creams/body lotions/oils on your skin on a daily basis, always use talcum powder. When waxing the male chest or back, always use talcum powder);
7) spread a thin layer of wax in the direction of the hair growth;
8) apply a strip of unwoven fabric to the wax, pressing it firmly with the palm of the hand;
9) remove the strip of unwoven fabric with one quick pull in the opposite direction of the hair growth; the same strip can be used for a number of applications. Remove the strip close to the skin/parallel to the skin. Keep ¼ or 1/3 of the strip free of wax to avoid risk of sticky fingers. Keep skin taut when removing the strip. Immediately after waxing an area, press again with the palm of the hand to desensitize the skin;

On sensitive area’s (armpits, face, bikiniline) do no apply wax twice on the same skin. If not all hairs have been removed, use a tweezer in stead of waxing the same area twice!

10) Repeat the operations indicated in points 7, 8 and 9 until the whole area has been waxed;
11) After depilation remove any residual sticky wax using the special afterwax oil (Nabehandelingolie).
12) Apply an afterwax cooling gel (Cooling gel met menthol)
13) Remove the plug from the socket and wait until the machine is completely cold before putting it away.